Accessories UFM Line5 | Extensive Selection

Properties of the PSB

We offer the PSB Safety Box as an option for our UFM Line5 universal joining modules. It is suitable as an alternative to control cabinet integration for production in automated assembly lines and contains all the necessary safety functions and power components. During development, emphasis was placed on fast commissioning and a compact design. The box can be conveniently mounted close to the servo press, reducing cable lengths and eliminating the need for wiring. Your servo press is therefore ready for operation within a very short time.

Advantages:

No need for integration in the control cabinet
Reduction in cable lengths
No wiring effort
No need to adapt the wiring diagrams
Fast commissioning: plug & play
PLe for STO as standard
IP54 protection
Extremely compact design
Extension to SLS, SS1, SS2 possible

Features of the PSD safety module

The safety module PSD RX is supplied as a ready-to-install and tested module. Among other things, it contains the power electronics and the safety control for the joining unit. The following safety functions can be realised: STO in Ple according to DIN ISO 13849-1; optional: SSx and SLS in PLd according to DIN ISO 13849-1 (for UFM Line5 RX with safety brake). The safety module facilitates and speeds up the commissioning of the assembly unit. It is suitable for our UFM Line5 units with and without brake, provided that it is controlled via a field bus.

Advantages:

Short commissioning times
No wiring effort
Completely checked and tested
EMC tested

Assembled components

AC servo amplifier with NC module
Braking Resistor
EMC components, mains filters
Safety control: Safety functions STO in Ple to DIN EN ISO 13849-1; optional: SSx and SLS in PLd to DIN ISO 13849-1 (for UFM Line5 with safety brake)
Fieldbus interface (must be ordered separately)
Cable set (must be ordered separately)
Required connections (connected to pins): Power supply
24-volt emergency stop circuit

Technical data

UFM Line5	Article-no.	WxHxD [mm]	Supply voltage	Frequency	Operating temperature range	Control voltage
10 kN	PSD010G1	357x475x300	380 - 480 VAC +/- 10 %, 3 ph	50 - 60 Hz	+ 5 - 40 °C	24 VDC +/- 10 %
30 kN	PSD030G1	500x500x300
60 kN	PSD060G1	500x500x300
100 kN	PSD100G1	500x500x350

Our robust C-frames are characterised by their good accessibility from the front and the side, their high rigidity and low bending. They are particularly suitable for integration into assembly lines or machines.

The lower plates are provided as standard with a central bore and 2-T-slots for optimum tool holding. The upper plates are completely prepared to accommodate the corresponding joining module.

Our four-column frames are suitable for applications with centric axial force application. They have the advantage of low bending, which only has a parallel effect.

The lower plates are provided as standard with a central bore and 2-T-slots for optimum tool holding. The upper plates are completely prepared to accommodate the corresponding joining module.